|
By Chris Tran, GM3WOJ/ZL1CT
|
HF Contesting Hints
Many newcomers to ham radio are unfamiliar with HF Contest operations. Based
on years of successful contesting, Chris explains how to get started.
Why enter an HF contest?
Well, they are a test of your operating and technical skill, competitiveness,
stamina, propagation knowledge, keyboard skills, equipment and antenna
reliability etc. etc. and always they are great fun !
Here's some help to get started ...
Operating
-
Whatever you do, do it quickly!
- in non-contest operating, about 80% of what
we say into a microphone is un-necessary information - in a contest this is
even more important. For example, it is particularly bad operating to give
long CQ calls (except occasionally in VHF/UHF contests) - if your signal is
strong, many stations will be standing by to call you, and will just be
frustrated if you give lengthy calls, and may not wait.
In major HF contests, you can simply say "Golf Mike Seven Victor" once (don't
even bother to say 'CQ' except every 4th or 5th call) and stations will call
you. The speed of operating has increased considerably in recent years, for a
variety of reasons, and contest exchanges have been reduced to the minimum
required. You can assume that the other station is glad to have worked you -
never say "thanks for the QSO OM, good luck in the contest" - this is an utter
waste of time (you probably don't mean it anyway!) - on most occasions a simple
"thanks" is sufficient.
-
Practice operating
- if you are new to contesting, or if you are not confident
about working stations quickly, enter a few contests from home as a single
operator - you will be the only person to judge how well you are doing, and you
can set yourself some targets e.g. 500 QSOs on 15m or similar - not too
ambitious at first. By listening to some of the world's top operators in
action, you can learn a lot more than by listening to some pundit in the local
club whose techniques date from the 1970s! (Listen to EA8BH (N5TJ) or ZD8Z
(N6TJ) - Jeff N5TJ is arguably the top phone operator in the world at the
moment, working over 10000 stations in 48 hours as a single-operator!) Know
when to fight to keep a frequency and when to QSY quickly. Choose the
phonetics for your callsign carefully. Practise listening to heavily-accented
English.
-
Know your equipment/software/antennas
- again time is wasted if you don't know how to operate your rig properly, how
to minimise interference, how to 'grab' cluster spots, which antenna is best
for a particular direction, etc. Operating conditions in a contest are very
different to day-to-day operation, so practise using your rig in high-QRM
situations. Practise keyboard skills - all contest stations should now use
computer logging, and the quicker you can type and correct errors the better.
-
Know the bands
- if you've decided to enter a 160m contest, for example, spend several weeks
listening/working on 160m before the contest to learn about propagation,
bandplan, etc.
Also contact friends who use 160m regularly and ask their advice on what to
expect at particular times of day, etc. Check propagation predictions. Be
prepared for unexpected propagation paths - often the increased activity
(especially with high-power contest stations) makes it possible to work unusual
paths.
-
Make an operating plan
- even if it's in your head, plan what to do for the whole 24/48 hours of the
contest - on paper you can divide the day into hour-long 'slots', and write
down (after studying old logs, etc) what you might expect to work in each hour.
When you get tired, this plan will help optimise your results. Plan
rest-breaks at low-activity times of day. Memorise prefixes to save time.
-
Choose the correct contest or section to enter
- HF contests have many different sections, and with relatively few GM/MM
stations entering contests, you should be able to win a certificate if you
choose a particular contest or contest section e.g. 15m CW Low-power, 40m SSB
High-power, etc.
-
Get fit!
- contesting is tiring - sitting for hours on end is bad for you - some
operators jump up and down and wave their arms periodically while operating (!)
to keep their circulation going (and avoid DVT!) Make sure there is plenty of
fresh air in the shack, bright lighting, and drink plenty (non-alcoholic
before/during the contest, alcoholic after!)
Make sure where you sleep is well away from bellowing operators or thundering
generators!
-
Watch the meters!
- ask the owner of the equipment how to tune the amplifier, what the anode/grid
currents, power outputs, etc should be. Check the meter readings regularly,
especially if you are changing bands
regularly. Stop transmitting and investigate any unusual readings before
something burns out.
-
Team Player
- If you're going to be part of a team, leave your ego at home - each of us
thinks that we are fairly efficient operators, but a team effort needs a team
approach, not a bunch of self-styled "Scotland's no.1 DX ers" all vying for
status - this is useless! We all have individual strengths and weaknesses
- the team should exploit the strengths and minimise the weaknesses. Don't be
afraid to say "I'm not sure what you expect me to do" or "what should I expect
to work at this time of day?" or to make suggestions based on your experience.
Equipment and Software
-
Good equipment
- use the best equipment you can afford - HF contesting can be as cheap or as
expensive as you want to make it - a good operator will achieve good results
with a modest station, but obviously for national/international success you
will need to invest in equipment, computers, antennas, etc. and have a suitable
site to install the station. For multi-transmitter set-ups, bandpass
filters are essential, and other techniques may be needed to reduce any
inter-station QRM.
-
Use the station before the contest
- reliability is increased considerably if you set up the station well in
advance, and use it regularly - faults/problems can be eliminated e.g.
r.f. pick-up in computers etc. In 'field-day' contests, try to use someone's
complete station which is used regularly at home rather then a hotch-potch of
many different stations.
-
Choice of transceiver
- many widely-advertised HF transceivers work well for day-to-day QSOs, but are
nearly useless under HF contest conditions. You need really good RX front-end
performance, and good I.F. filtering - in my experience DSP is almost useless
for improving readability of SSB signals - if there is local inter-station QRM
from a nearby transmitter on another band, DSP may try to 'interpret' the audio
components, and actually makes readability worse! DSP only does one thing
well - 'Tracking Auto-notch' removal of carriers is spectacularly effective!
For SSB, buy a 1.8kHz or 2.0kHz filter (for the 1st 8.2MHz IF) and for CW buy a
250Hz filter (you will hear about 4 QSOs at once with the average 500Hz
filter!) The major manufacturers cannot make these extra filters with good
shape factors - buy them from some of the specialist American suppliers.
-
Choice of amplifier
- most HF amplifiers are not designed for the stress of a 24 or 48-hour
contest - generally they are not properly cooled. Ensure that your amplifier
is positioned so that it gets a supply of cold air, not recycled heat. Fit an
extra fan, especially to cool the transformer and other p.s.u. components. If
the amplifier is slightly under-run it will be more reliable.
-
Station accessories/set-up
- for SSB, you will need 'hands-free' operation - a headset and a footswitch
- ideally the footswitch should switch the amplifier which in turns switches
the transceiver, this is usually faster. A 'Voice-keyer' conserves your voice
when the band is quiet, and allows you to keep up a high TX/RX ratio - there is
however a school of thought that if you are using a voice keyer on some bands
you are not working enough stations ! For CW, you should be using the computer
keyboard to work stations, with a keyer/paddle in parallel for slower QSOs or
for other exchanges. Get a (not-too) comfortable operating chair,
and lay out the keyboard/transceiver etc at a distance/height which doesn't
give you aches and pains after a few hours of operating. Make sure you can
see the dials, monitor, meters etc without having to move much.
-
Choice of software
- there are a wide variety of contest-logging programs, which all basically do
the same job - they log the QSOs, allow you to check for 'dupes', keep track of
your QSO rate, countries worked, etc. Before you buy software, make sure you
try it - does it do what you need it to do? - for example one
'highly-recommended' logging program does not allow you to type on the
keyboard while it is sending CW - this is a really annoying deficiency.
Memorise common software commands, and have large wall-charts listing all
commands/keystrokes. Make sure all operators know what to do if the software
'crashes'.
Antennas and Feeders
-
Use the best antenna you can
- antennas are the key to success in all aspects of our hobby - for contesting
they are the deciding factor. If possible, use computer-optimised monoband
beams for 40m-10m and phased antennas like the 4-square for 80m, and seriously
high antennas for 160m. For 160m in particular, antenna height is crucial.
Install and test the antenna weeks before the contest. If possible, avoid
using antennas that need matching in the shack with an a.t.u. - any antenna
tuner introduces losses, and it is difficult to run high power with an a.t.u.
-
Use the best feeder
- RG213U as a minimum and ideally LDF4-50 Heliax - never use RG58 for any
antenna ! Use the minimum number of connectors in your feeder system.
Open-wire feeders have very low losses, but are often not practical, and need
an a.t.u. Test the feeders regularly - feed 10W of RF in one end and check
how much reaches the other end - for about 100' of feeder at 28 MHz : LDF4-50 =
more than 8W : RG213U = 6W approximately.
-
Check the performance of antennas
- test the SWR and check (for a beam) the gain/ front-to-back if possible -
keep a written/graphical note of the readings to allow you to compare the
antenna performance later.
73 and good luck
Chris, GM3WOJ/ZL1CT
|